Indicadores socieconômicos e criação de áreas naturais protegidas em Minas Gerais

Nature Protection Areas (NPA) are important in the modern world, although still created with no well-defined criteria, overall in state and municipal spheres. In addition, there are no consistent information on the existence or factors that influence the creation and distribution of these areas. The present work had the objectives of identifying the Nature Protection Areas in Minas Gerais, Brazil, considering the municipalities and their mesoregions; perform a space-temporal analysis of the NPAs in Minas Gerais; relate the existence of NPAs with the Municipal Human Development Index (MHDI) and the municipal Gini Index (GI); relate the existence of NPA with the space-temporal and population density of each municipality; relate the Gross Domestic Product (GDP) with the presence of NPAs; relate the existence of NPAs with the occurrence of preservation areas in municipalities within the Atlantic Forest Biome; and verify the influence of the Ecological Sales and Services Tax (Ecological ICMS) institute over the creation of municipal NPAs in Minas Gerais. To reach these objectives, we researched databases, governmental websites, contacted managers and sent questionnaires to the 853 municipalities of Minas Gerais. After tabulating the data, statistical tests were applied to verify possible correlations. The results showed that the state has 9.26% of its territory protected, with the predominance of units of Sustainable Use, especially Environmental Protection Areas, which constitute 69.9% of this area. Only 1.96% of the territory are protected by Integral Protection (IP). We found no correlation between MHDI and the presence of NPAs. However, we verified that municipalities with IP units present higher GI when compared to the others, suggesting that the presence of this conservation unit (CU) model may be associated to social inequality. The results also showed a higher concentration CU in regions that use little of its natural resources as main economic basis and in municipalities with higher GDP. We also registered a positive correlation between the size of the municipalities, of the mesoregions, preserved area of the Atlantic Forest and population density. The Ecological ICMS did not contribute for a better IP in the state and, currently, does not represent an incentive to the creation of CU in Minas Gerais, even in the case of Environmental Protection Areas. This work registered a high degree of vulnerability if the protection system in this state, based on low restriction conservation units.

Modificação superficial de fibras de juta com descarga corona para melhora da aderência com matriz poliéster

Seeking alternatives for the total or partial substitution of synthetic fibers for natural fibers, with reinforcement in polymeric materials, this work was conducted with the objective of evaluating the treatment with corona discharge on the adherence of juta fibers with resin. The fibers were exposed to corona discharge for 1, 5, 10 and 15 minutes, as well as after treatment with hot water, molding composites fiber-reinforced with filaments treated for 10 and 15 minutes, and without the treatment. The chemical structures were evaluated by spectrometry in the region of Fourier transform infrared with attenuated total reflection (FTIR/ATR), observing the formation of a new band and the increase in the absorption of groupings with oxygen. The thermal analyses, such as thermogravimetry (TG) and differential scanning calorimetry (DSC) revealed the degradation of cellulose, hemicellulose and lignin. The microstructural characterization by scanning electron microscopy (SEM) showed changes in the surface of the fiber, such as roughness, superficial depressions, surface degradation and cavity formation. The adhesion of the fibers was evaluated by the pullout test, allowing us to verify the increase in adhesion strength after treatment with corona discharge. In conclusion, the treatment with corona discharge changes the surface of the juta fibers, resulting in better adherence with the resin.